A product that makes home building easier, faster, more efficient and more environmentally friendly. A revolutionary structural system in the construction and renovation market.SEE SPECIFICATIONS
OSBLOCK redefines traditional building techniques by offering a modular and structural product that allows for quick and easy wall installation while exceeding current energy efficiency and durability standards.
DISCOVER Use your cursor to view the OSBLOCK from different angles of view. (The current model may vary from the 3D model)
INSTALL THE STARTING LINES Choose option A or B
1.1 Extend a line around the floor and apply urethane.
1.2 Install the starter bar and secure with two 3 ½ inch screws every 24 inches or so.
2.1 Apply urethane to the corner of the rail.
2.2 Insert the corner end of the corner into the corner of the starting rail.
2.3 Secure the corner to the starting rail with 3 ½ "screws.
2.4 Level the corner and hold it with two temporary furs.
3.1 Cut the OSBLOCK to the desired length and at right angles so that the end of the Osblock to be attached to the corner is without a male or female tip.
3.2 Insert the plastic wall latches under the OSBLOCKs.
3.3 Apply urethane to the starting rail.
4.1 It is best to leave at least 6 inches between the joints of the OSBLOCK.
4.2 Apply urethane to the female part of the OSBLOCK and insert the top block.
4.3 Insert the 14 inch ratchet wrench extension into the holes provided and rotate the polymer lock 1/4 turn using the ratchet wrench.
5.1 When opening windows, use the top rail as the bottom of the window.
5.2 Apply urethane to the female part and secure the OSBLOCK with 3 ½ inch screws every 24 inches.
See the manual for more
6.1 The end plate will be used as support for your roof trusses or joists.
6.2 Apply the urethane and insert the end plate.
6.3 Secure the rail with 3 ½ "screws.
7.1 Support the floor joists on the end rail above the first floor wall.
7.2 Install the floor of the second floor.
7.3 Repeat all steps of wall mounting.
8.1 Inject urethane and place insulation around the bottom rail (inside and outside).
8.2 Inject the urethane into the corners (inside and outside).
8.3 If necessary, place an air baffle and vertical furs on the outside wall (not supplied).